The Hytrol Blog



Material handling insights. Industry trends. Hytrol news. Get it all on The Hytrol Blog.


Subscribe

  We are going to learn how to replace a sweeper cartridge on a Prosort SS. Using recommended safety gear and following proper lockout tagout procedures, unplug the power and communication cables from the motor and disconnect the photo eye.
Ask Hytrol
   Today we are going to discuss how to track a belt on a roller or slider bed conveyor. Using recommended safety gear, follow these steps for pre-tracking inspection. Lockout-tagout prior to physical inspection.
      Welcome to Ask Hytrol. Today we are going to discuss squaring a conveyor bed frame using cross bracing.
      Today, we’re going to discuss how to properly tension and track a belt on a model ABEZ conveyor.
In today's Ask Hytrol video, we're going to discuss how to address a misaligned V-belt on an LRC. One of the most important preventative maintenance items on Hytrol’s V-belt driven models is to check for proper V-belt and sheave alignment.
In today's Ask Hytrol video, we’re going to discuss how to configure the loading and unloading zones on an EZLogic® zone controller using the Genesis software. When a product is placed in a zone (a loading zone) or removed from a zone (an unloading zone) by some external means, the EZLogic® zone controller may be programmed to stop the zone and accumulate any upstream products for a preset time.
In today's Ask Hytrol video, we’re going to discuss how to replace a belt on the ProSort MRT. This task is recommended for two people. So before you get started, have someone assist you with the following steps: Following proper lock-out tag-out procedures, begin by removing the four bolts holding the wear strip support channel in place. Slide the channel toward the discharge end of the conveyor until it pulls free from the wear strip, then pull off to either side of the conveyor.
    In today's Ask Hytrol video, we're going to talk about how to install a Hytrol gear reducer. Models 4AC and 5AC speed reducers are supplied with a "C-Face" adapter and may be coupled directly to the motor via coupling gears and a sleeve. During installation, it is recommended to use the supplied Hytrol Motor Coupling Gage for accurately locating both coupling gears to their correct setting on the shaft.
      In this Ask Hytrol video, we’re going to talk about how to install Hytrol’s E24™ 3.0 card. The E24™ 3.0 card offers increased versatility and reliability over the previous generation. To install this technology, follow proper lock-out tag-out procedures and then mount the control in a location where the motor cable reaches the connection header, but does not strain the cable connector or header. Select the motor you will be using by matching the control settings to the motor in use. Turn s...
    In today's Ask Hytrol video, we're going to demonstrate how to set the speed using the dip switches on the E24i™ motor.  There are six numbered dip switches located on the E24i motor. When the dip switches are aligned on the right, they are in the ON position. When they are aligned on the left, they are in the OFF position. Switches 1 and 2 are read only at power up, which means any changes to the switches will not work until the power is cycled to the E24i™.
      Today, we're going to demonstrate how simple it is to replace a drop-in pulley. With its quick-change capabilities, this pulley's drop-in design allows for minimal downtime on the production floor. This style of pulley can be found on the induction units of models ProSort 100, ProSort 400, before and after the divert buckets on the ProSort SC, and on the model Gapper. Here's how to replace a drop-in pulley: