Ask Hytrol: How to Install an EZLogic® NET Gateway
For this Ask Hytrol, we walk through how to properly install an EZLogic® NET Gateway on your conveyor system.
Tag Hytrol How-To
Ask Hytrol: How to Install a Shaft-Mounted Drive
In this Ask Hytrol, we’ll demonstrate how to properly install a shaft-mounted drive on a Hytrol conveyor.
Hytrol How-To: Reset All EZLogic® Zones to ABEZ Default Settings
In this Hytrol How-To, you will learn how to reset all EZLogic® zones to ABEZ default settings. First, connect the push button programmer to the discharge controller. Push and hold down both buttons for over one second. Next, press the…
Hytrol How-To: E24™ Dip Switch Capabilities
In this Hytrol How-To, you will learn the various functions of the E24™ Dip Switch. There are four numbered dip switches located on the E24™ motor card. When the switches are aligned on the left, they are in the OFF…
Hytrol How-To: Change an Air Bag in the Brake System
In this Hytrol How-To, you will learn how to change an air bag in the brake system on your conveyor. Begin by taking out the rollers that hold the brake in place and removing the airline connected to the air bag.…
Hytrol How-To: Adjust the Pressure Frame on the ABEZ Conveyor
In this Hytrol How-To, you will learn how to adjust the pressure frame on the ABEZ conveyor. Steps for adjusting the pressure frame on the ABEZ conveyor: If the drive pressure on your ABEZ conveyor is not functioning properly, you’ll…
Hytrol How-To: Determine Which Air Regulator to Use on the ABEZ
In this Hytrol How-To, you will learn how to determine which air regulator to use on the ABEZ conveyor system. Hytrol’s ABEZ conveyor uses a specially designed air regulator with a gold cap to control its air bag system that…
Hytrol How-To: Tighten Drive Chain Tension
In this Hytrol How-To, you will learn how to tighten the drive chain tension on your conveyor. Steps for tightening the drive chain tension: 1. Once the power to the conveyor has been turned off and locked out, remove the…